When.com Web Search

  1. Ads

    related to: radiant heat on existing slab construction

Search results

  1. Results From The WOW.Com Content Network
  2. Underfloor heating - Wikipedia

    en.wikipedia.org/wiki/Underfloor_heating

    A.M. Byers of America promotes radiant heating using small bore water pipes. Asia continues to use traditional ondol and kang—wood is used as the fuel, combustion gases sent under floor. 1930: Oscar Faber in England uses water pipes used to radiant heat and cool several large buildings. [15] 1933

  3. Radiant heating and cooling - Wikipedia

    en.wikipedia.org/wiki/Radiant_heating_and_cooling

    Radiant heating and cooling is a category of HVAC technologies that exchange heat by both convection and radiation with the environments they are designed to heat or cool. There are many subcategories of radiant heating and cooling, including: "radiant ceiling panels", [ 1 ] "embedded surface systems", [ 1 ] "thermally active building systems ...

  4. Gypsum concrete - Wikipedia

    en.wikipedia.org/wiki/Gypsum_concrete

    Gypsum concrete is lightweight and fire-resistant. A 1.5-inch slab of gypsum concrete weighs 13 pounds per square foot versus 18 pounds per square foot for regular concrete. [10] Even though gypsum concrete weighs less, it still has the same compressive strength as regular concrete, based on its application as underlayment or top coat flooring ...

  5. Underfloor air distribution - Wikipedia

    en.wikipedia.org/wiki/Underfloor_air_distribution

    The ground floor with a slab on grade has less temperature rise compared to middle and top floors, and an increase of the supply air temperature causes a decrease in the temperature rise. The temperature rise is not significantly affected by the perimeter zone orientation, the internal heat gain and the window-to-wall ratio. [16]

  6. Interior radiation control coating - Wikipedia

    en.wikipedia.org/wiki/Interior_radiation_control...

    The energy conserving property has been defined as thermal emittance (the ability of a surface to release radiant energy that it has absorbed). Those coatings qualified as Interior Radiation Control Coatings must show a thermal emittance of 0.25 or less. This means that an IRCCS will block 75% or more of the radiant heat transfer. These low "E ...

  7. 50 Times Cheap Fixes Had A Major Impact On Home Life - AOL

    www.aol.com/55-people-share-relatively-cheap...

    $300 of blown in insulation and radiant barrier for the attic. ... up the back wall and around the tub. Used cheap molding to frame the existing large over sink mirror. ... Poured a 20x20 concrete ...

  1. Ads

    related to: radiant heat on existing slab construction