Ad
related to: concrete column detail example
Search results
Results From The WOW.Com Content Network
A reinforced concrete column is a structural member designed to carry compressive loads, composed of concrete with an embedded steel frame to provide reinforcement. For design purposes, the columns are separated into two categories: short columns and slender columns.
Modern columns may be constructed out of steel, poured or precast concrete, or brick, left bare or clad in an architectural covering, or veneer. Used to support an arch, an impost, or pier, is the topmost member of a column. The bottom-most part of the arch, called the springing, rests on the impost.
Strengths above 40 MPa (5,800 psi) are often used for specific building elements. For example, the lower floor columns of high-rise concrete buildings may use concrete of 80 MPa (11,600 psi) or more, to keep the size of the columns small. Bridges may use long beams of high-strength concrete to lower the number of spans required.
A concrete frame, also known as a concrete skeleton, is a structure composed of interconnected beams, columns, and slabs that is used to support larger structures. [ 1 ] [ 2 ] Due to the low cost of producing them, concrete frames are often used when building damns, bridges, and buildings.
An example of a catenary-shaped suspended structure is the Eero Saarinen designed Dulles International Airport. The roof of the structure is made up of suspension cable which stretches across angled concrete columns. In the design of Dulles airport, the floor, the columns and the roof all work together to allow the walls and ceiling to float. [6]
A strap footing is often used in conjunction with columns that are located along a building's property or lot line. Typically, columns are centered on column footings, but in conditions where columns are located directly adjacent to the property line, the column footings may be offset so that they do not encroach onto the adjacent property. [3]
Waffle slabs are preferred for spans greater than 40 feet (12 m), because, for a given mass of concrete, they are much stronger than flat slabs, flat slabs with drop panels, two-way slabs, one-way slabs, and one-way joist slabs. [2] Section of a waffle slab including beam, ribs, and column head
Examples of these include: elevators, structural steel, trusses, pre-cast concrete, windows, appliances, cabinets, air handling units, and millwork. Also critical are the installation and coordination shop drawings of the MEP trades such as sheet metal ductwork, piping, plumbing, fire protection, and electrical.