Search results
Results From The WOW.Com Content Network
They show an almost linear increase in lift coefficient with increasing angle of attack with a gradient known as the lift slope. For a thin airfoil of any shape the lift slope is π 2 /90 ≃ 0.11 per degree. At higher angles a maximum point is reached, after which the lift coefficient reduces.
The rates of change of lift and drag with angle of attack (AoA) are called respectively the lift and drag coefficients C L and C D. The varying ratio of lift to drag with AoA is often plotted in terms of these coefficients. For any given value of lift, the AoA varies with speed. Graphs of C L and C D vs. speed are referred to as drag curves ...
One digit describing the lift coefficient in tenths. Two digits describing the maximum thickness in percent of chord. For example, the NACA 16-123 airfoil has minimum pressure 60% of the chord back with a lift coefficient of 0.1 and maximum thickness of 23% of the chord.
The significant aerodynamic properties of aircraft wings are summarised by two dimensionless quantities, the lift and drag coefficients C L and C D. Like other such aerodynamic quantities, they are functions only of the angle of attack α, the Reynolds number R e and the Mach number M. C L and C D can be plotted against α, or can be plotted ...
= (,,) drag coefficient equation. The aerodynamic efficiency has a maximum value, E max, respect to C L where the tangent line from the coordinate origin touches the drag coefficient equation plot. The drag coefficient, C D, can be decomposed in two ways. First typical decomposition separates pressure and friction effects:
The number of vortices used vary with the required pressure distribution resolution, and with required accuracy in the computed aerodynamic coefficients. A typical number of vortices would be around 100 for an entire aircraft wing; an Aeronautical Research Council report by Falkner published in 1949 mentions the use of an "84-vortex lattice ...
Lift is proportional to the density of the air and approximately proportional to the square of the flow speed. Lift also depends on the size of the wing, being generally proportional to the wing's area projected in the lift direction. In calculations it is convenient to quantify lift in terms of a lift coefficient based on these factors.
The coefficient of lift for a two-dimensional airfoil section with strictly horizontal surfaces can be calculated from the coefficient of pressure distribution by integration, or calculating the area between the lines on the distribution. This expression is not suitable for direct numeric integration using the panel method of lift approximation ...