Ads
related to: wheel stopper dimension from the wall hole bolt set for concrete
Search results
Results From The WOW.Com Content Network
Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
The bolt holes are spaced evenly about the bolt hole circle. Wheel studs are the bolts that are on your mounting hub and are used along with lug nuts to attach the wheel to the car. The bolt hole circle is the circle that the center of each bolt aligns with.
Bolted joint in vertical section Screw joint. The distinction between a bolt and a screw is poorly defined. The academic distinction, per Machinery's Handbook, [3] is in their intended purpose: bolts are designed to pass through an unthreaded hole in a component and be fastened with the aid of a nut.