Search results
Results From The WOW.Com Content Network
Without knowing the clock frequency it is impossible to state if one set of timings is "faster" than another. For example, DDR3-2000 memory has a 1000 MHz clock frequency, which yields a 1 ns clock cycle. With this 1 ns clock, a CAS latency of 7 gives an absolute CAS latency of 7 ns. Faster DDR3-2666 memory (with a 1333 MHz clock, or 0.75 ns ...
For example, a system with an external clock of 100 MHz and a 36x clock multiplier will have an internal CPU clock of 3.6 GHz. The external address and data buses of the CPU (often collectively termed front side bus (FSB) in PC contexts) also use the external clock as a fundamental timing base; however, they could also employ a (small) multiple ...
Further, a "cumulative clock rate" measure is sometimes assumed by taking the total cores and multiplying by the total clock rate (e.g. a dual-core 2.8 GHz processor running at a cumulative 5.6 GHz). There are many other factors to consider when comparing the performance of CPUs, like the width of the CPU's data bus , the latency of the memory ...
In digital electronic design a clock domain crossing (CDC), or simply clock crossing, is the traversal of a signal in a synchronous digital circuit from one clock domain into another. If a signal does not assert long enough and is not registered, it may appear asynchronous on the incoming clock boundary.
One drawback of using source-synchronous clocking is the creation of a separate clock-domain at the receiving device, namely the clock-domain of the strobe generated by the transmitting device. This strobe clock-domain is often not synchronous to the core clock domain of the receiving device. For proper operation of the received data with other ...
The gap between processor speed and main memory speed has grown exponentially. Until 2001–05, CPU speed, as measured by clock frequency, grew annually by 55%, whereas memory speed only grew by 7%. [1] This problem is known as the memory wall. The motivation for a cache and its hierarchy is to bridge this speed gap and overcome the memory wall.
When a program wants to time its own operation, it can use a function like the POSIX clock() function, which returns the CPU time used by the program. POSIX allows this clock to start at an arbitrary value, so to measure elapsed time, a program calls clock(), does some work, then calls clock() again. [1] The difference is the time needed to do ...
That assist with advanced computer-aided design tools which includes a complete simulation of system board. This die contains the 386 CPU core, AT Bus Controller, Memory Controller, Internal Bus Controller, Cache Control Logic along with Cache Tag SRAM and Clock. This CPU contains 855,000 transistors using one-micron CHMOS IV technology.