Search results
Results From The WOW.Com Content Network
BTO/C – break to open/close (valve torque) BTU – British thermal units; BTU – Board of Trade Unit (1 kWh) (historical) BU – bottom up; BUL – bottom-up lag; BUR – build-up rate; BVO – ball valve operator; bwd – barrels of water per day (often used in reference to oil production) bwipd – barrels of water injected per day
Unlock and open, then close and relock the vent and drain valves. Unlock and open door, load pig into launcher, close and lock door. Unlock and open valves V1 and V3, to create a flow path through the launcher. Partly close ‘kicker’ valve V2 to launch the pig. The launch alarm XA will indicate when the pig has been launched. Open valve V2 ...
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
Saddle valve: where allowed, is used to tap a pipe for a low-flow need; Schrader valve: holds the air inside automobile tires; Security valve, a type of automatic shut-off valve (ASV): used to stop the flow of natural gas upon sudden pressure changes. Increased pressure or decreased pressure closes the valve (without using any external power ...
Valves stop (or regulate) the flow of liquids or gases. They are categorized by application, such as isolation, throttling, and non-return. Isolation valves temporarily disconnect part of a piping system to allow maintenance or repair, for example. Isolation valves are typically left in either a fully open or closed position.
The blue valve body is visible in-line with the pipe. The valve actuator opens or closes the butterfly disc of the valve based on electrical signals sent to the actuator. Another valve actuator is visible in the background, with windows to indicate the valve position. A valve actuator is the mechanism for opening and closing a valve. Manually ...
Undetected, water hammer can rupture pumps, valves, and pipes within the system. [9] The flapper valve in a flush-toilet mechanism is an example of this type of valve. Tank pressure holding it closed is overcome by manual lift of the flapper. It then remains open until the tank drains and the flapper falls due to gravity.
Using an always-open or always-closed valve called a tap, pipe layers connect them to a wider system and bury the pipes. whereas, Pipe fitters plan and test piping and tubing layouts; cut, bend or fabricate pipe or tubing segments; and join those segments by threading them, using lead joints, welding, brazing, cementing, or soldering them together.