Search results
Results From The WOW.Com Content Network
Measuring the compressive strength of a steel drum. In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
The strength of materials is determined using various methods of calculating the stresses and strains in structural members, such as beams, columns, and shafts. The methods employed to predict the response of a structure under loading and its susceptibility to various failure modes takes into account the properties of the materials such as its yield strength, ultimate strength, Young's modulus ...
Fig. 1: Critical stress vs slenderness ratio for steel, for E = 200 GPa, yield strength = 240 MPa. Euler's critical load or Euler's buckling load is the compressive load at which a slender column will suddenly bend or buckle. It is given by the formula: [1] = where
A diametral compression test involves applying a stress load or force to the point where a material object is split in half (down the diameter of the object). [1] This test indirectly measures the tensile property of a material object, as the molecules of the material are pushed apart in opposite directions, similar to what happens to molecules in a direct tensile strength test.
The ultimate tensile strength is usually found by performing a tensile test and recording the engineering stress versus strain. The highest point of the stress–strain curve is the ultimate tensile strength and has units of stress. The equivalent point for the case of compression, instead of tension, is called the compressive strength.
Young's modulus is the slope of the linear part of the stress–strain curve for a material under tension or compression. Young's modulus (or Young modulus) is a mechanical property of solid materials that measures the tensile or compressive stiffness when the force is applied lengthwise. It is the modulus of elasticity for tension or axial ...
In order to calculate the value of BCT (Box compression test), the formula of McKee would be the easiest but also the least accurate [opinion]. The ratio of height to the circumference must be greater than 1:7; even then, are many reservations. Simplified McKee formula:
Compression set A is defined as the percentage of original specimen thickness after the specimen has been left in normal (uncompressed) conditions for 30 minutes. C A, the compression set A is given by C A = [(t o - t i) / t o] * 100 where t o is the original specimen thickness and t i is the specimen thickness after testing. [2]