Ads
related to: gm parts diagrams online
Search results
Results From The WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
GM's Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydramatic introduced in 1940. [1] The Hydramatic was a big success, and had been installed in the majority of GM models by 1950.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
Turbo-Hydramatic 425 (TH425 or THM 425, [1] later 325) was an automatic transmission developed and produced by General Motors.The THM425 was a derivative of the THM400; most parts directly interchange and some others will interchange with minor modifications.
By the mid-1990s, the 4T60-E was the transmission of choice in nearly every front-wheel drive GM vehicle with the exception of compacts. A heavy-duty 4T60-E HD was produced in 1996 for the supercharged GM 3800 engine and reused in mid 2005 to 2009 with an LS4 5.3 liter V8 in four different models the Buick Lacrosse Super, Chevrolet Impala SS ...