Ad
related to: yaesu 2m 70cm transceiver receiver wiring diagram
Search results
Results From The WOW.Com Content Network
The transceiver can transmit and receive on the HF 10-, 15-, 20-, 40-, 80- and 160-meter bands, [33] and can receive WWV and WWVH on 15 MHz. It can use SSB , FSK and CW on all bands. [ 33 ] The TS-820S' power consumption is 57 watts (with heaters on) when receiving and 292 watts when transmitting.
The Yaesu VX-1R is a micro-miniature multiband FM transceiver with extensive receiver frequency coverage intended for use in licensed "Ham" or amateur radio operations. It is purportedly the smallest UHF/VHF hand-held transceiver available, with dimensions of 4.7 × 8.1 × 2.5 cm (1.9 × 3.2 × 1.0 in).
The FT-817 is based on a similar circuit architecture as Yaesu's FT-857 and FT-897, so it is a compromise transceiver and incorporates its features to its low price ($670.- at its 2001 release). [3] The upgraded FT-817(N)D was launched in 2004. The difference between the two models is the addition of 60 meter band coverage in 5 fixed channels ...
Starting in April 2004 Icom began releasing new "D-STAR optional" hardware. The first to be released commercially, was a 2-meter mobile unit designated IC-2200H. Icom followed up with 2 meter and 440 MHz handheld transceivers the next year. However, the yet to be released UT-118 add-on card was required for these radios to operate in D-STAR mode.
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
The Yaesu FT-2900R is a VHF 2M FM mobile amateur radio transceiver. It is no longer in production and has been replaced by the FT-2980. It is no longer in production and has been replaced by the FT-2980.
Yaesu became an important presence in the U.S. amateur radio market with the introduction and improvement of its very popular FT-101 line of equipment in the 1970s. In addition, transceiver manufacture was outsourced to Henry Radio in Los Angeles. Sako Hasegawa died in 1993. Following his death, Jun Hasegawa took over as managing director.
The receiver is filtered by a 22 pole crystal filter with switchable extra 8 and 6 pole narrow band CW filters, a 14 pole SSB filter and a separate 14 pole CW filter. The RF circuit is based on a – manually or automatically – microprocessor controlled PIN diode attenuator with 2 bipolar power transistors used as a high level RF amplifier in the receive mode and as a double RF output pre ...