Search results
Results From The WOW.Com Content Network
A SpaceWire router is usually a crossbar switch-type device, operating in wormhole switching mode. This also may limit the speed of the communication to the lowest common speed. [ 3 ] The routing decisions are based on the programmed routing table and the initial incoming frame contents.
The other extreme is where a computer job uses one or few nodes, and needs little or no inter-node communication, approaching grid computing. In a Beowulf cluster , the application programs never see the computational nodes (also called slave computers) but only interact with the "Master" which is a specific computer handling the scheduling and ...
A physical network node is an electronic device that is attached to a network, and is capable of creating, receiving, or transmitting information over a communication channel. [1] In data communication, a physical network node may either be data communication equipment (such as a modem , hub , bridge or switch ) or data terminal equipment (such ...
A wireless ad hoc network does not have fixed topology, and its connectivity among nodes is totally dependent on the behavior of the devices, their mobility patterns, distance with each other, etc. Hence, wireless mesh networks are a particular type of wireless ad hoc networks, with special emphasis on the resultant network topology.
Sending data from sub to main may use the opposite clock edge as main to sub. Devices often require extra clock idle time before the first clock or after the last one, or between a command and its response. Some devices have two clocks, one to read data, and another to transmit it into the device. Many of the read clocks run from the chip ...
For example, if a local software utility or set of device drivers are needed in order to support a locally attached peripheral device (e.g. printer, scanner, biometric security device), the thin client operating system may lack the resources needed to fully integrate the required dependencies (although dependencies can sometimes be added if ...
Increasing the transmission power of the nodes can solve the hidden node problem by allowing the cell around each node to increase in size, encompassing all of the other nodes. This configuration enables the non-hidden nodes to detect, or hear, the hidden node. If the non-hidden nodes can hear the hidden node, the hidden node is no longer hidden.
Note: In the Defense Data Network (DDN), a packet-switching node is usually configured to support up to thirty-two X.25 56 kbit/s host connections, as many as six 56 kbit/s interswitch trunk (IST) lines to other packet-switching nodes, and at least one Terminal Access Controller (TAC).