When.com Web Search

  1. Ads

    related to: stove pipe finishing collar size

Search results

  1. Results From The WOW.Com Content Network
  2. Aplysina archeri - Wikipedia

    en.wikipedia.org/wiki/Aplysina_archeri

    Aplysina archeri, also known as a stove-pipe sponge because of its shape, is a species of tube sponge that has long tube-like structures of cylindrical shape. Although they can grow in a single tube, they often grow in large groups of up to 22 tubes. [ 2 ]

  3. Pipe clamp - Wikipedia

    en.wikipedia.org/wiki/Pipe_clamp

    A short pipe clamp. In woodwork, a pipe clamp uses clamp heads produced commercially by numerous manufacturers. They are available in various diameter sizes, commonly ½”or ¾”, suited to the same diameter piping. The pipe is usually threaded on both ends. One head is fixed on the pipe by spinning it onto standard pipe threads.

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [ 15 ] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size.

  5. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  6. Bottom hole assembly - Wikipedia

    en.wikipedia.org/wiki/Bottom_hole_assembly

    Rotary assemblies [2] are commonly used where formations are predictable and the rig economics are an issue. In such an assembly the weight of the drill collars gives the BHA the tendency to sag or flex to the low side of the hole, collar stiffness length and stabiliser diameter and placement are engineered as a means of controlling the flex of the BHA.

  7. JIC fitting - Wikipedia

    en.wikipedia.org/wiki/JIC_fitting

    A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right. JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface.