When.com Web Search

  1. Ads

    related to: one sata cable two drives usb port price in south africa

Search results

  1. Results From The WOW.Com Content Network
  2. SATA - Wikipedia

    en.wikipedia.org/wiki/SATA

    A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...

  3. Hard disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Hard_disk_drive_interface

    A data cable (top) and control cable (below) connecting a controller card and an ST-506 type HDD. Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data.

  4. Port multiplier - Wikipedia

    en.wikipedia.org/wiki/Port_multiplier

    A Serial ATA port multiplier is a unilateral splitting device. While it allows one equipped port to connect up to 15 disks, the bandwidth available is limited to the bandwidth of the link to the controller, as of 2012 1.5, 3, or 6 Gbit/s. [3]

  5. USB - Wikipedia

    en.wikipedia.org/wiki/USB

    Devices that draw more than one unit are high-power devices (such as typical 2.5-inch hard disk drives). USB up to 2.0 allows a host or hub to provide up to 2.5 W to each device, in five discrete steps of 100 mA, and SuperSpeed devices (USB 3.x) allows a host or a hub to provide up to 4.5 W in six steps of 150 mA.

  6. SCSI connector - Wikipedia

    en.wikipedia.org/wiki/SCSI_connector

    Normally, hard disk drives make use of two cables: one for data and one for power, and they also have their specific parameters (SCSI ID etc.) to be set using jumpers on each drive. Drives employing SCA have only one plug which carries both data and power and also allows them to receive their configuration parameters from the SCSI backplane.

  7. M.2 - Wikipedia

    en.wikipedia.org/wiki/M.2

    Used for SATA SSDs, and interfaced through the AHCI driver and legacy SATA 3.0 (6 Gbit/s) port exposed through the M.2 connector. PCI Express using AHCI Used for PCI Express SSDs and interfaced through the AHCI driver and provided PCI Express lanes, providing backward compatibility with widespread SATA support in operating systems at the cost ...