Ads
related to: tire stabilizer bar links problems- Shop for Tires
Find Tires That Fit Your Vehicle
and Drive Confidently.
- Current Deals and Rebates
View Our Exclusive Offers and
Save on Top Brands Today.
- Locations & Hours
Find Store Hours and a
Location Near You.
- Military Discount 5% Off
Instant 5% off of Total Invoice
For All Military Personnels.
- Shop for Tires
Search results
Results From The WOW.Com Content Network
An anti-roll bar (roll bar, anti-sway bar, sway bar, stabilizer bar) is an automobile suspension part that helps reduce the body roll of a vehicle during fast cornering or over road irregularities. It links opposite front or rear wheels to a torsion spring using short lever arms for anchors. This increases the suspension's roll stiffness—its ...
George Caramagna, a mechanic working on the suspension system, suggested installing a stabilizer (anti-roll or "anti-sway") bar, but was overruled by GM management. [citation needed] To make up for the cost-cutting lack of a front stabilizer bar, Corvairs required tire pressures which were outside of the tire manufacturers' recommended tolerances.
In the attached photo of a 5-link live axle suspension, the different types of links can be seen. These links work in tandem with the coil springs, dampers, and sway bar to control all six degrees of freedom of the axle. The upper links (orange) and the lower links (yellow) work in tandem to control the pitch, yaw and the fore and aft movement ...
Suspensions with other devices, such as sway bars that link the wheels in some way, are still classed as independent. Semi-dependent suspension is a third type. In this case, the motion of one wheel does affect the position of the other, but they are not rigidly attached to each other. Twist-beam rear suspension is such a system.
Swing axle suspensions often used leaf springs and shock absorbers, though later Mercedes-Benz applications used coil springs and the VW beetle swing axle was torsion bar sprung. One problem inherent in the swing axle concept is that it almost inevitably results in a very high roll centre which causes detrimental jacking effects and camber ...
Despite the drawbacks, the MacPherson strut set-up is still used on some high performance cars, because they tend to have relatively small suspension travel, and so do not have the same kinematic problems. Up until the 1989 model year (964), Porsche 911 used a similar strut design that did not have coil springs, using torsion bar suspension ...