When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. These Simple Fixes For Drafty Windows Will Help You ... - AOL

   www.aol.com/simple-fixes-drafty-windows-help...

   Insulating Window Treatments: Cellular or multi-layer window coverings can also be another helpful insulating solution. They provide an extra layer to stop heat loss and block drafts.

3. Flashing (weatherproofing) - Wikipedia

   en.wikipedia.org/wiki/Flashing_(weatherproofing)

   In earlier days, birch bark was occasionally used as a flashing material. [7] Most flashing materials today are metal, plastic, rubber, or impregnated paper. [8]Metal flashing materials include lead, aluminium, copper, [1] stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminium, terne-coated copper ...

4. Window film - Wikipedia

   en.wikipedia.org/wiki/Window_film

   The ceramic and metallic window films usually cost 50-100+ percent more than regular window film but they can reduce energy transmission by as much as 80 percent. [4] Ceramic window films cost slightly more but provide a substantial increase by reflecting and absorbing infrared radiation (IR or radiant heat).

5. Hot-melt adhesive - Wikipedia

   en.wikipedia.org/wiki/Hot-melt_adhesive

   Ethylene-vinyl acetate (EVA) copolymers, low-performance, the low-cost and most common material for the glue sticks (e.g., the light amber colored Thermogrip GS51, GS52, and GS53). [9] They provide sufficient strength between 30 °C (86 °F) and 50 °C (122 °F) but are limited to use below 60 °C (140 °F) to 80 °C (176 °F) and have low ...

6. Polyvinyl chloride - Wikipedia

   en.wikipedia.org/wiki/Polyvinyl_chloride

   In Europe, particularly Belgium, there has been a commitment to eliminate the use of cadmium (previously used as a part component of heat stabilizers in window profiles) and phase out lead-based heat stabilizers (as used in pipe and profile areas) such as liquid autodiachromate and calcium polyhydrocummate by 2015.

7. Flash (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Flash_(manufacturing)

   Flash, also known as flashing, is excess material attached to a molded, forged, or cast product, which must usually be removed. This is typically caused by leakage of the material between the two surfaces of a mold (beginning along the parting line [ 1 ] ) or between the base material and the mold in the case of overmolding .