Search results
Results From The WOW.Com Content Network
A poorly-graded soil is a soil that does not have a good representation of all sizes of particles from the no. 4 to no. 200 sieve. A poorly-graded gravel is classified as GP, while a poorly-graded sand is classified as SP. Poorly-graded soils are more susceptible to soil liquefaction than well-graded soils. [1]
clean gravel <5% smaller than No.200 Sieve GW well-graded gravel, fine to coarse gravel GP poorly graded gravel gravel with >12% fines GM silty gravel GC clayey gravel sand ≥ 50% of coarse fraction passes No.4 (4.75 mm) sieve clean sand SW well-graded sand, fine to coarse sand SP poorly graded sand sand with >12% fines SM silty sand SC
The original Proctor test, ASTM D698 / AASHTO T99, uses a 4-inch-diameter (100 mm) by 4.584-inch-high (116.4 mm) mold which holds 1/30 cubic feet of soil, and calls for compaction of three separate lifts of soil using 25 blows by a 5.5 lb hammer falling 12 inches, for a compactive effort of 12,375 ft-lbf/ft 3.
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
If the soil particles in a sample are predominantly in a relatively narrow range of sizes, the sample is uniformly graded. If a soil sample has distinct gaps in the gradation curve, e.g., a mixture of gravel and fine sand, with no coarse sand, the sample may be gap graded. Uniformly graded and gap graded soils are both considered to be poorly ...
The USCS further subdivides the three major soil classes for clarification. It distinguishes sands from gravels by grain size, classifying some as "well-graded" and the rest as "poorly-graded". Silts and clays are distinguished by the soils' Atterberg limits, and thus the soils are separated into "high-plasticity" and "low-plasticity" soils ...
The plastic limit (PL) is determined by rolling out a thread of the fine portion of a soil on a flat, non-porous surface. The procedure is defined in ASTM Standard D 4318. If the soil is at a moisture content where its behavior is plastic, this thread will retain its shape down to a very narrow diameter.
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils. Based on this history it has also been called the "Dutch ...