Search results
Results From The WOW.Com Content Network
The D-subminiature or D-sub is a common type of electrical connector. They are named for their characteristic D-shaped metal shield. They are named for their characteristic D-shaped metal shield. When they were introduced, D-subs were among the smallest connectors used on computer systems.
The historical connector used by MDA, EGA and CGA graphic cards is a female nine-pin D-subminiature . The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15)
D-subminiature connectors are used to carry balanced analog or digital audio on many multichannel professional audio equipment, where the use of XLR connectors is impractical, for example due to space constraints.
D-subminiature 15-pin Composite. Often designated by the CVBS acronym, meaning "Color, Video, Blank and Sync". RCA jack, normally yellow (often accompanied with red and white for right and left audio channels respectively) S-Video (Separate Video). Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin ...
The VGA connector is a three-row, 15-pin D-subminiature connector referred to variously as DE-15, [2] HD-15 or commonly DB-15(HD). DE-15 is the accurate nomenclature under the proprietary D-sub specifications: an "E" size D-sub connector, with 15 pins in three rows.
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.
Presence of a 25-pin D-sub connector does not necessarily indicate an RS-232-C compliant interface. For example, on the original IBM PC, a male D-sub was an RS-232-C DTE port (with a non-standard current loop interface on reserved pins), but the female D-sub connector on the same PC model was used for the parallel "Centronics" printer port ...
Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).