Search results
Results From The WOW.Com Content Network
triatic stay is a stay that runs between masts. On a ketch it runs between the main mast and the head of the mizzen mast and is used to stop the upper section of the mizzen mast being pulled backwards. On a steamer, an iron bar between the two knees secures the paddle-beams. (See funnel stays).
1. That part of the ocean lying more than a few hundred nautical mile s from shore, and thus beyond the outer boundary of green water. 2. More generally, the open ocean or deep sea. blue-water navy 1. A navy capable of sustained operations in the open ocean, beyond a few hundred nautical miles from shore. 2.
On a sailing vessel, a forestay, sometimes just called a stay, is a piece of standing rigging which keeps a mast from falling backwards. It is attached either at the very top of the mast, or in fractional rigs between about 1/8 and 1/4 from the top of the mast. The other end of the forestay is attached to the bow of the boat.
Glossary of nautical terms may refer to: Glossary of nautical terms (A–L) Glossary of nautical terms (M–Z) This page was last edited on 21 December 2024 ...
Unlike the cutter staysail, none of these sails have their luff affixed to a stay. On large rigs, staysails other than headsails are named according to the mast and mast section on which they are hoisted. Thus, the staysail hoisted on a stay that runs forward and downwards from the top of the mizzen topgallant mast is the mizzen topgallant ...
Most fore-and-aft rigged vessels have the following types of standing rigging: a forestay, a backstay, and upper and lower shrouds (side stays). Less common rigging configurations are diamond stays and jumpers. Both of these are used to keep a thin mast in column especially under the load of a large down wind sail or in strong wind.
Theme words stay highlighted in blue when found. Drag or tap letters to create words. If tapping, double tap the last letter to submit. Theme words fill the board entirely. No theme words overlap.
Original usage in 18th and 19th century square-rigged ships distinguished between the fore staysail, set on the forestay running from the foremast head to the ship's peak, the foremost part of the hull, and the jibs set on stays running to the bowsprit. Jibs, but not staysails, could also be "set flying," i.e. not attached to the standing rigging.