When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]

3. Lightbulb socket - Wikipedia

   en.wikipedia.org/wiki/Lightbulb_socket

   GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing GU8 – same as G8 and only denotes what lamp mount clip is needed to hold the actual light bulb in place; GY8.6 – 8.6 mm (0.33858 in) pin spacing; G9 – 9 mm (0.35433 in) pin spacing

4. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

5. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

6. Wedge base - Wikipedia

   en.wikipedia.org/wiki/Wedge_base

   A wedge base is a type of electrical connector used as a fitting for small light bulbs. It is similar to the bi-pin connector , except that the two "pins" are the same wires that extend into the bulb (rather than being rigid), and the wires are bent up onto the sides of the base, where they make contact with the socket.

7. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   Efficiency: LEDs emit more lumens per watt than incandescent light bulbs. [63] The efficiency of LED lighting fixtures is not affected by shape and size, unlike fluorescent light bulbs or tubes. Size: LEDs can be very small (smaller than 2 mm 2 [64]) and are easily attached to printed circuit boards.