Ads
related to: exterior stone veneer wainscoting pictures
Search results
Results From The WOW.Com Content Network
A water table is a projection of lower masonry on the outside of a wall, slightly above the ground, or at the top of a wainscot section of a wall (in this case also known as a sill). It is both a functional and architectural feature that consists of a projection that deflects water running down the face of a building away from lower courses or ...
Most exterior veneer systems hang stone from a support wall by pins and anchors allowing air space between, essentially using stone as a rain screen. Anchorage systems are superior for exterior use because they permit any water that permeates the veneer to escape, while air space allows the materials of the supporting substrate wall to expand ...
A single wythe of brick that is not structural in nature is referred to as a masonry veneer. A multiple-wythe masonry wall may be composed of a single type of masonry unit layered to increase its thickness and structural strength, or different masonry units chosen by function, such as an economical concrete block serving a structural purpose ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
The exterior is 4 + 1 ⁄ 2-inch stone veneer quarried in Philadelphia and applied with a special mortise technique. The circular drive arrives at a matching stone portico with a tongue and groove ceiling and Spanish tile porch. The roof is tile with a hip and valley on the wing side and a hip roof on the rectangular side.
Stone veneer is used as a protective and decorative covering for interior or exterior walls and surfaces. The veneer is typically 1 in (25.4 mm) thick and must weigh less than 15 lb per square foot (73 kg m −2) so that no additional structural supports are required. The structural wall is put up first, and thin, flat stones are mortared onto ...