Search results
Results From The WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI (Open Systems Interconnection) network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer.
Router R1 is a one-armed router carrying out inter-VLAN routing. A router on a stick, also known as a one-armed router, [1] [2] is a router that has a single physical or logical connection to a network. It is a method of inter-VLAN routing where one router is connected to a switch via a single cable. The router has physical connections to the ...
The main purpose of a router is to connect multiple networks and forward packets destined either for directly attached networks or more remote networks. A router is considered a layer-3 device because its primary forwarding decision is based on the information in the layer-3 IP packet, specifically the destination IP address. When a router ...
(Note that the term 'trunk' is also used for what Cisco calls "channels" : Link Aggregation or Port Trunking). A router (Layer 3 device) serves as the backbone for network traffic going across different VLANs. It is only when the VLAN port group is to extend to another device that tagging is used.
Cisco Express Forwarding (CEF) is an advanced layer 3 switching technology used mainly in large core networks or the Internet to enhance the overall network performance. . Although CEF is a Cisco proprietary protocol other vendors of multi-layer switches or high-capacity routers offer a similar functionality where layer-3 switching or routing is done in hardware (in an ASIC) instead of by ...
End-stations and servers connect to the enterprise at the access layer. Access layer devices are usually commodity switching platforms, and may or may not provide layer 3 switching services. The traditional focus at the access layer is minimizing "cost-per-port": the amount of investment the enterprise must make for each provisioned Ethernet ...
Layer-3 switching is solely based on the (destination) IP address stored in the header of an IP datagram (layer-4 switching may use other information in the header). The difference between a layer-3 switch and a router is the way the device is making the routing decision.