When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. SK Hand Tools - Wikipedia

   en.wikipedia.org/wiki/SK_Hand_Tools

   SK Hand Tools (styled earlier as S-K, now usually SK) is a tool company located in Sycamore, Illinois, with additional manufacturing facilities in China, Taiwan, and Colorado Springs, Colorado. [1] Outlets for their products include independent tool-truck dealers, auto parts stores, and major internet vendors such as Sears and Amazon.com .

3. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   Screwdriver with rubber handle. The tool used to drive a slotted screw head is called a standard, common blade, flat-blade, slot-head, straight, flat, flat-tip, [6] or "flat-head" [7] screwdriver. This last usage can be confusing, because the term flat-head also describes a screw with a flat top, designed to install in a countersunk hole ...

4. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   There were 3 different size spring chucks, and therefore 3 different shank size tips or sometimes called points, to fit various models. Generally all tips made by North Brothers or Stanley were stamped with the corresponding number of the model screwdriver they would fit, but the stamped numbers are often difficult to see, so it's a good idea to know the size you need before you set out to ...

5. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.

6. Tap wrench - Wikipedia

   en.wikipedia.org/wiki/Tap_wrench

   The clamp is opened to insert the tool and then tightened down against the tool to secure it. This type of tap wrench is used with larger taps and where there is room to turn a larger wrench. [1] A T-handle is more compact. This type of wrench uses a collet to secure the tool. The collet design has two pieces: a threaded "nosecap" and four ...

7. J.H. Williams Tool Group - Wikipedia

   en.wikipedia.org/wiki/J.H._Williams_Tool_Group

   The company was one of the first to offer mass-produced drop-forged hand tools. [3] A second factory was opened in Buffalo, New York in 1914, now the site of General Motors' Tonawanda Engine plant. [4] The company was acquired by Snap-on in 1993. [citation needed] In 2011 it was officially renamed Snap-on Industrial Brands. [5]