Ads
related to: dish plus antenna replacement parts diagram 1 2
Search results
Results From The WOW.Com Content Network
A satellite dish is a dish-shaped type of parabolic antenna designed to receive or transmit information by radio waves to or from a communication satellite. The term most commonly means a dish which receives direct-broadcast satellite television from a direct broadcast satellite in geostationary orbit .
Parabolic antennas are based on the geometrical property of the paraboloid that the paths FP 1 Q 1, FP 2 Q 2, FP 3 Q 3 are all the same length. Thus, a spherical wavefront emitted by a feed antenna at the dish's focus F will be reflected into an outgoing plane wave L travelling parallel to the dish's axis VF.
2-way DiSEqC switch 4-way DiSEqC switch with attached coaxial cables.. DiSEqC (/ ˈ d aɪ s ɛ k, d aɪ ˈ s ɛ k s i /; [citation needed] short for Digital Satellite Equipment Control) is a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small [1] dish antenna rotor.
Feed horn with concentric rings (left) and LNB (right) on a Hughes DirecWay home satellite dish. An LNBF (LNB with integrated feed horn) that has been cut into two.Visible is the scalar horn antenna (the funnel with concentric rings), which couples the microwave beam into a short waveguide (the tube connecting the feed horn to the LNB electronics part of the LNBF).
The category of simple antennas consists of dipoles, monopoles, and loop antennas. Nearly all can be made with a single segment of wire (ignoring the break made in the wire for the feedline connection). [citation needed] Dipoles and monopoles called linear antennas (or straight wire antennas) since their radiating parts lie along a single ...
Diagram of a beam waveguide antenna from NASA, showing the signal path (red). A beam waveguide antenna is a particular type of antenna dish, at which waveguides are used to transmit the radio beam between the large steerable dish and the equipment for reception or transmission, like e.g. RF power amplifiers.
Indoor antennas are designed to be located on top of or next to the television set, but are ideally placed near a window in a room and as high up as possible for the best reception. [1] The most common types of indoor antennas are the dipole [2] ("rabbit ears"), which work best for VHF channels, and loop antennas, which work best for UHF. [3]
The dish antenna occupies the high frequencies (typically 950 to 1450 MHz), and the TV antenna uses lower television channel frequencies (typically 50 to 870 MHz). In addition, the satellite also gets a DC to low frequency band to power the dish's block converter and select the dish antenna polarization (e.g., voltage signaling or DiSEqC ).