Search results
Results From The WOW.Com Content Network
PCV valve on Ford Taunus V4 engine (feeding from left side valve cover into the inlet manifold) A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold).
A hydrolock occurs when a liquid fills a combustion chamber to the point that it is impossible to turn the crankshaft without a catastrophic failure of the engine or one of its vital components. The conventional remedy for a flooded carbureted engine is to steadily hold the throttle full open (full power position) while continuing to crank the ...
A harmonic balancer (sometimes called crankshaft damper, torsional damper, or vibration damper) is the same thing as a harmonic damper except that the balancer includes a counterweight to externally balance the rotating assembly. The harmonic balancer often serves as a pulley for the accessory drive belts turning the alternator, water pump and ...
It is a myth that in certain circumstances, a lifter can "pump up" and create negative valve clearance. The engine oil pump cannot generate enough pressure to cause "pump-up". The problem is due to weak valve springs which permit float at high engine speeds. The followers attempt to take up what they see as extra clearance.
This is because the big end of the connecting rod swings from side to side, so that the motion of the small end deviates from ideal sinusoidal motion between top and bottom dead centre on each swing, i.e. twice per crank revolution, and the distance the small end (and a piston connected to it) has to travel in the top 180° of crankshaft ...
The Ford 427 block was closer dimensionally to the smaller 392 cu. in. first generation Chrysler FirePower Hemi; the Ford FE's bore spacing was 4.63 in (117.6 mm) compared to the Chrysler 392's 4.5625 in (115.9 mm). The Ford FE's deck height of 10.17 in (258.3 mm) was lower than that of the Chrysler 392 at 10.87 in (276.1 mm).
The bottom end of a pushrod is fitted with a lifter, upon which the camshaft makes contact. The camshaft lobe moves the lifter upwards, which moves the pushrod. The top end of the pushrod pushes on the rocker arm, which opens the valve.
This engine was the first to locate one balance shaft higher than the other, to counteract the second order rolling couple (i.e. about the crankshaft axis) due to the torque exerted by the inertia caused by increases and decreases in engine speed. [6] [7] In a flat-four engine, the forces are cancelled out by the pistons moving in opposite ...