Search results
Results From The WOW.Com Content Network
On automobiles, disc brakes are often located within the wheel A drilled motorcycle brake disc. The development of disc-type brakes began in England in the 1890s. In 1902, the Lanchester Motor Company designed brakes that looked and operated similarly to a modern disc-brake system even though the disc was thin and a cable activated the brake pad. [4]
The Citroën 2CV (French: deux chevaux, pronounced [dø ʃ(ə)vo], lit. "two horses", meaning "two taxable horsepower") is an economy car produced by the French company Citroën from 1948 to 1990. Introduced at the 1948 Paris Salon de l'Automobile , [ 1 ] it has an air-cooled engine that is mounted in the front and drives the front wheels .
Car and Driver found the Pinto, when equipped with the larger 2.0L engine and front disc brakes, to be a nimble and powerful commuter car with good visibility and sports-car feel. [51] A review of the 1974 Pinto with an automatic transmission by Car and Driver was not as favorable noting significant decreases in mileage and acceleration. [52]
The 1968 VAM Javelin featured the 155 hp (116 kW; 157 PS), 8.5:1 compression ratio 232 cu in (3.8 L) I6 engine with a two-barrel Carter WCD carburetor, a 3.54:1 rear differential gear ratio, 12-inch heavy-duty clutch, manual four-wheel drum brakes, quick-ratio manual steering, electric wipers, electric washers, 8,000 RPM tachometer, 200 km/h ...
Compared to modern disc brakes, drum brakes wear out faster due to their tendency to overheat. The disc brake is a device for slowing or stopping the rotation of a road wheel. A brake disc (or rotor in U.S. English), usually made of cast iron or ceramic, is connected to the wheel or the axle.
Full-size GM vans continued featuring drum brakes for several more years, transitioning entirely to disc brakes by 2003. [5] The original design of the braking system within the 14-bolt differentials accommodated diverse wheel sizes, initially fitting drums suitable for 15-inch wheels and later adapting to cater to the needs of 3/4-ton and 1 ...
The MGA design dates back to 1951, when MG designer Syd Enever created a streamlined body for George Philips' TD Le Mans car. The new bodywork traded the MG TF's articulated fenders and running board for ponton styling, with a single styled envelope fully enclosing the width and uninterrupted length of a car.
Although disc brakes had been tried on a car as early as 1902 by British Lanchester, volume production had not been applied until 1949, by USA small car manufacturer Crosley, but without success. The Citroën DS was the first successful fielding of disc brakes on a mass-produced car. [4]