Ad
related to: how to determine memory speedavg.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
The naming convention for DDR, DDR2 and DDR3 modules specifies either a maximum speed (e.g., DDR2-800) or a maximum bandwidth (e.g., PC2-6400). The speed rating (800) is not the maximum clock speed, but twice that (because of the doubled data rate). The specified bandwidth (6400) is the maximum megabytes transferred per second using a 64-bit width.
The gap between processor speed and main memory speed has grown exponentially. Until 2001–05, CPU speed, as measured by clock frequency, grew annually by 55%, whereas memory speed only grew by 7%. [1] This problem is known as the memory wall. The motivation for a cache and its hierarchy is to bridge this speed gap and overcome the memory wall.
A model, called Concurrent-AMAT (C-AMAT), is introduced for more accurate analysis of current memory systems. More information on C-AMAT can be found in the external links section. AMAT's three parameters hit time (or hit latency), miss rate, and miss penalty provide a quick analysis of memory systems. Hit latency (H) is the time to hit in the ...
When translating memory timings into actual latency, timings are in units of clock cycles, which for double data rate memory is half the speed of the commonly quoted transfer rate. Without knowing the clock frequency it is impossible to state if one set of timings is "faster" than another.
It depends on the rotational speed of a disk (or spindle motor), measured in revolutions per minute (RPM). [ 5 ] [ 23 ] For most magnetic media-based drives, the average rotational latency is typically based on the empirical relation that the average latency in milliseconds for such a drive is one-half the rotational period.
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
Outside of specific contexts, computer performance is estimated in terms of accuracy, efficiency and speed of executing computer program instructions. When it comes to high computer performance, one or more of the following factors might be involved: Short response time for a given piece of work.
A memory divider is a ratio which is used to determine the operating clock frequency of computer memory in accordance with front side bus (FSB) frequency, if the memory system is dependent on FSB clock speed. Along with memory latency timings, memory dividers are extensively used in overclocking memory subsystems to find stable, working memory ...