Ads
related to: tow bar lock pin
Search results
Results From The WOW.Com Content Network
A tow hitch (or tow bar or trailer hitch in North America [1]) is a device attached to the chassis of a vehicle for towing, or a towbar to an aircraft nose gear. It can take the form of a tow ball to allow swiveling and articulation of a trailer , or a tow pin, or a tow hook with a trailer loop, often used for large or agricultural vehicles ...
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
The coupling consists of a kingpin, a 2-or-3 + 1 ⁄ 2-inch-diameter (50.8 or 88.9 mm) vertical steel pin protruding from the bottom of the front of the semi-trailer, and a horseshoe-shaped coupling device called a fifth wheel on the rear of the towing vehicle. As the connected truck turns, the downward-facing surface of the semi-trailer (with ...
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
The most common drawbar configuration for heavy vehicles is an A-frame drawbar at the front of a full trailer that connects to a tow coupling on a hauling vehicle [1] On heavy vehicles, the drawbar is coupled using a drawbar eye , typically of 40 mm or 50 mm diameter, connected to a bolt and pin coupling.