When.com Web Search

  1. Ads

    related to: cost to install flagstone walkway

Search results

  1. Results From The WOW.Com Content Network
  2. Flagstone - Wikipedia

    en.wikipedia.org/wiki/Flagstone

    Flagstone (flag) is a generic flat stone, sometimes cut in regular rectangular or square shape and usually used for paving slabs or walkways, patios, flooring, fences and roofing. It may be used for memorials, headstones , facades and other construction.

  3. Permeable paving - Wikipedia

    en.wikipedia.org/wiki/Permeable_paving

    Some estimates put the cost of permeable paving at about one third more expensive than that of conventional impervious paving. [20] Using permeable paving, however, can reduce the cost of providing larger or more stormwater BMPs on site, and these savings should be factored into any cost analysis. In addition, the off-site environmental impact ...

  4. Arlington Memorial Amphitheater - Wikipedia

    en.wikipedia.org/wiki/Arlington_Memorial...

    The repairs included installation of new waterproof membranes; removing water and rust stains; patching and repainting cement, marble, and stone; replacement of all deteriorated marble sculptures, balusters, and benches; replacement of worn and rusted iron railings and drinking fountains; replacement of worn and broken flagstone walkways; and ...

  5. Road surface - Wikipedia

    en.wikipedia.org/wiki/Road_surface

    In addition to repair costs, the condition of a road surface has economic effects for road users. Rolling resistance increases on rough pavement, as does wear and tear of vehicle components. It has been estimated that poor road surfaces cost the average US driver $324 per year in vehicle repairs, or a total of $67 billion.

  6. Pavers (flooring) - Wikipedia

    en.wikipedia.org/wiki/Pavers_(flooring)

    The base layer should be 6" deep for walkways, or 12" deep for driveways. [10] The base material should either be 3/4" crushed stone (to allow water to drain through it) for a 1/4" crushed stone bedding, or 3/4" minus crushed stone (to prevent sand from sinking through it) for a concrete sand bedding. The base should be compacted every 6".

  7. Resin-bound paving - Wikipedia

    en.wikipedia.org/wiki/Resin-bound_paving

    The ratio of resin to aggregate should be at the optimal amount (7% resin to aggregate) depending on the application and environment type, and stone type which should be kiln dried mixed aggregate incorporating 2-5 mm sizes to ensure that the aggregate gets sufficiently coated and also to meet the standard requirements when tested to BS 8204-6: ...