Search results
Results From The WOW.Com Content Network
cubic foot per minute CFM [citation needed] ≡ 1 ft 3 /min = 4.719 474 432 × 10 −4 m 3 /s: cubic foot per second ft 3 /s ≡ 1 ft 3 /s = 0.028 316 846 592 m 3 /s: cubic inch per minute in 3 /min ≡ 1 in 3 /min = 2.731 177 3 × 10 −7 m 3 /s cubic inch per second in 3 /s ≡ 1 in 3 /s = 1.638 7064 × 10 −5 m 3 /s: cubic metre per second ...
inch-hour-minute-second: ... US spelling: cubic centimeter one millilitre 1.0 ... l/km usgal/mi; miles per imperial gallon mpgimp mpgimp mpgus;
litres per hour: liter per hour: liters per hour: impgal/h USgal/h: Cubic metre per second: L/min: L/min: 0.001/60: litre per minute: litres per minute: liter per minute: liters per minute: impgal/min USgal/min: Cubic metre per second: L/s: L/s: 0.001: litre per second: litres per second: liter per second: liters per second: cuft/s: Cubic metre ...
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min. These standard conditions vary according to different regulatory bodies.
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
For liquids, various units are used depending upon the application and industry, but might include gallons (U.S. or imperial) per minute, liters per second, liters per m 2 per hour, bushels per minute or, when describing river flows, cumecs (cubic meters per second) or acre-feet per day.
For example, 10 miles per hour can be converted to metres per second by using a sequence of conversion factors as shown below: = . Each conversion factor is chosen based on the relationship between one of the original units and one of the desired units (or some intermediary unit), before being rearranged to create a factor that cancels out the ...