When.com Web Search

  1. Ads

    related to: how to calculate tap depth of water level in basement roof construction

Search results

  1. Results From The WOW.Com Content Network
  2. Water level (device) - Wikipedia

    en.wikipedia.org/wiki/Water_level_(device)

    The water level at each end of the tube will be at the same elevation, whether the two ends are adjacent or far apart, so a line between them will be horizontal at its midpoint and a shed base, building foundation or similar structure laid out using several such lines will be "horizontal" within building tolerances on any scale over which use ...

  3. Drainage equation - Wikipedia

    en.wikipedia.org/wiki/Drainage_equation

    d = equivalent depth, a function of L, (Di-Dd), and r; r = drain radius (m) Steady (equilibrium) state condition In steady state, the level of the water table remains constant and the discharge rate (Q) equals the rate of groundwater recharge (R), i.e. the amount of water entering the groundwater through the watertable per unit of time.

  4. Standard step method - Wikipedia

    en.wikipedia.org/wiki/Standard_Step_Method

    Upstream, the water surface must rise from a normal depth of 0.97 m to 9.21 m at the gate. The only way to do this on a mild reach is to follow an M1 profile. The same logic applies downstream to determine that the water surface follows an M3 profile from the gate until the depth reaches the conjugate depth of the normal depth at which point a ...

  5. Invert level - Wikipedia

    en.wikipedia.org/wiki/Invert_level

    Conversely, the obvert level is the highest interior level, and can be considered the "ceiling" level, being the highest level of that sewer. The bottom of the sewer is called the invert from a general resemblance in construction to an "inverted" arch. [2] An inverted arch is a rounded structure with its crown facing in the downward position.

  6. Drawdown (hydrology) - Wikipedia

    en.wikipedia.org/wiki/Drawdown_(hydrology)

    It is the height of the free surface of water above a given point beneath the surface. [4] Pumping level is the level of water in the well during pumping. [8] Specific capacity is the well yield per unit of drawdown. [8] Static level is the level of water in the well when no water is being removed from the well by pumping. [8]

  7. Hydraulic head - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_head

    In an aquifer, it can be calculated from the depth to water in a piezometric well (a specialized water well), and given information of the piezometer's elevation and screen depth. Hydraulic head can similarly be measured in a column of water using a standpipe piezometer by measuring the height of the water surface in the tube relative to a ...