Ads
related to: m5 to inches fraction table printable form download template
Search results
Results From The WOW.Com Content Network
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
ftin (feet and inches) ft m (foot m) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Other: nautical mile: nmi nmi the international standard nautical mile For other nautical miles see the full list. 1.0 nmi (1.9 km; 1.2 mi) parsec: pc pc 1.0 pc (3.3 ly) light-year: ly ly 1.0 ly (63,000 AU)
A fraction is applied to the output unit (if there is only one), or to non-SI units (if using a combination), except that if a precision is also specified, the fraction only applies to the hand unit. {{convert|18.45|in|m|frac=2}} → 18.45 inches ( 1 ⁄ 2 m)
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
A template for displaying common fractions of the form int+num/den nicely. It supports 0–3 anonymous parameters with positional meaning. Template parameters [Edit template data] Parameter Description Type Status leftmost part 1 Denominator if only parameter supplied. Numerator if 2 parameters supplied. Integer if 3 parameters supplied. If no parameter is specified the template will render a ...
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...