Search results
Results From The WOW.Com Content Network
Automixers balance multiple sound sources based on each source's level, quickly and dramatically adjusting the various signal levels automatically. [2] Automixers are used in live sound reinforcement to maintain a steady limit on the overall signal level of the microphones; if a public address system is set up so that one microphone will not feed back, then, in general, the automixer will ...
A 3.5 mm microphone blocker with just TS channel is enough to disconnect the internal microphone, but most commercial microphone blockers have TRRS connections which in theory makes them headset blockers that in smartphones also disconnect the internal speaker in media player software because they will try to connect to the headphones, while ...
To maximize gain before feedback, the amount of sound energy that is fed back to the microphones must be reduced as much as is practical.As sound pressure falls off with 1/r with respect to the distance r in free space, or up to a distance known as reverberation distance in closed spaces (and the energy density with 1/r²), it is important to keep the microphones at a large enough distance ...
Here, the still-mic-level signal enters into a microphone preamplifier, which boosts the signal voltage to line level. For this example, the microphone preamplifier is built into a mixing board. It is typical for a mixing board to include a line trim after the preamplifier. This allows the amplitude of the now line-level signal to be adjusted.
The position of the pop filter is different in different recording situations, with a further position from the microphone causing fewer pop sounds. More distance means increasing the microphone gain and gaining more room noise. Normally, to get good quality, the pop filter should be placed about 2–6 inches (5–15 cm) away from the ...
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio.
In both fields the amount of gain is measured in decibels at or just below the point at which the sound from the speaker driver re-enters the microphone and the system begins to ring or feed back. Potential acoustic gain (PAG) is a calculated figure representing gain that a system can support without feeding back. [1]
Spill occurs when sound is detected by a microphone not intended to pick it up (for example, the vocals being detected by the microphone for the guitar). [3] Spill is often undesirable in popular music recording, [4] as the combined signals during the mix process can cause phase cancellation and may cause difficulty in processing individual tracks. [2]