Ad
related to: snotter rope size
Search results
Results From The WOW.Com Content Network
A snotter is a rope or tackle used in sailing to tension the sprit on a spritsail, or a sprit boom on a sprit-boomed sail by pulling the lower end towards the mast. It is also used in a junk rig . There are a great many variations on the snotter arrangement, and some more fastidious authors have referred to it as a snouter or snorter .
a type of jam of the rope on a winch drum: the heavily loaded part of the rope unintentionally rises over the successive turn s on the winch, so stopping them from moving. [37] rig 1. The arrangement of masts, sails, and rigging on a sailing vessel. [38] 2. To fit a sailing vessel with its masts, sails or rigging. [38] rigging
The fore end of the boom is tensioned (pulled tight to the mast) by use of a snotter chord. It is a precursor of the wishbone rig first popularised by windsurfers. On a Bolger 59 (square foot) rig, there is a 14'3" luff, 13'7" leech and 9'0" foot.
A pilot ladder has specific regulations on step size, spacing and the use of spreaders. It is the use of spreaders (long treads that extend well past the vertical ropes) in a pilot ladder that distinguishes it from a Jacob's ladder. When not being used, the ladder is stowed away, usually rolled up, rather than left hanging.
The Official Table of Drops, formerly issued by the British Home Office, is a manual which is used to calculate the appropriate length of rope for long drop hangings. Following a series of failed hangings, including those of John Babbacombe Lee , a committee chaired by Henry Bruce, 1st Baron Aberdare was formed in 1886 to discover and report on ...
Can I tie a knot on a foot-long rope that is one inch thick? In terms of ropelength, this asks if there is a knot with ropelength 12 {\displaystyle 12} . The answer is no: an argument using quadrisecants shows that the ropelength of any nontrivial knot has to be at least 15.66 {\displaystyle 15.66} . [ 1 ]
The length of these fids is typically 21 or 22 times the diameter of rope to be spliced. A one-half-inch (12.7 mm) diameter rope would have any accompanying fid 10.5–11 in (266.7–279.4 mm) in length with hash-marks denoting the long and short fid measurements. A short fid is 1 ⁄ 3 a fid length and a long fid is 2 ⁄ 3 the overall fid length.
A bight is a slack part in the middle of a rope, usually a curve or loop. [1] [2] Knots that can be tied without access to either end of the rope are called knots in the bight. To tie a knot with a bight is to double up the rope into a bight and then tie the knot using the double rope.