When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Grease fitting - Wikipedia

   en.wikipedia.org/wiki/Grease_fitting

   The grease gun hose is usually at a sharp angle (e.g. 70-90°) to the axis of the nipple but can be approached from any azimuthal angle. It is not possible for grease pressure to force this type of connector away from the nipple. Grease fittings are commonly made from zinc-plated steel, stainless steel, or brass.

3. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   In plumbing, the term "45-degree elbow" for example, refers to the angle of bend from the original straight pipe position (0 degrees) to the new position (45 degrees), not the actual angle formed by the joint. On a protractor, the actual angle of the above joint is 135 degrees, an obtuse angle.

5. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Alternatively it is a short length of pipe with two female National pipe threads (NPT) (in North American terms, a coupler is a double female while a nipple is double male) or two male or female British standard pipe threads. If the two ends of a coupling are of different standards or joining methods, the coupling is called an adapter. Examples ...

6. Angle bracket (fastener) - Wikipedia

   en.wikipedia.org/wiki/Angle_bracket_(fastener)

   An angle bracket or angle brace or angle cleat is an L-shaped fastener used to join two parts generally at a 90-degree angle. It is typically made of metal but it can also be made of wood or plastic. Angle brackets feature holes in them for screws. A typical example use of is a shelf bracket for mounting a shelf on a wall.

7. Universal joint - Wikipedia

   en.wikipedia.org/wiki/Universal_joint

   and it is seen that the output drive is just 90 degrees out of phase with the input shaft, yielding a constant-velocity drive. NOTE: The reference for measuring angles of input and output shafts of universal joint are mutually perpendicular axes. So, in absolute sense the forks of the intermediate shaft are parallel to each other.