Search results
Results From The WOW.Com Content Network
NAT hairpinning, also known as NAT loopback or NAT reflection, [27] is a feature in many consumer routers [28] where a machine on the LAN is able to access another machine on the LAN via the external IP address of the LAN/router (with port forwarding set up on the router to direct requests to the appropriate machine on the LAN).
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
UPnP Internet Gateway Device Protocol (UPnP IGD) is supported by many small NAT gateways in home or small office settings. It allows a device on a network to ask the router to open a port. Interactive Connectivity Establishment (ICE) is a complete protocol for using STUN and/or TURN to do NAT traversal while picking the best network route ...
Port triggering is a configuration option on a NAT-enabled router that controls communication between internal and external host machines in an IP network. It is similar to port forwarding in that it enables incoming traffic to be forwarded to a specific internal host machine, although the forwarded port is not open permanently and the target internal host machine is chosen dynamically.
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Switching loops can cause misleading entries in a switch's media access control (MAC) database and can cause endless unicast frames to be broadcast throughout the network. A loop can make a switch receive the same broadcast frames on two different ports, and alternatingly associate the sending MAC address with the one or the other port.
NetFlow is a feature that was introduced on Cisco routers around 1996 that provides the ability to collect IP network traffic as it enters or exits an interface. By analyzing the data provided by NetFlow, a network administrator can determine things such as the source and destination traffic, class of service, and the causes of congestion.
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.