Ads
related to: new yaesu transceiver antenna replacement cable parts ebay amazongigaparts.com has been visited by 10K+ users in the past month
smartholidayshopping.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
A Yaesu FT-101EE tuned to 7.180 (LSB) MHz.Many users left the protective plastic covering on to protect the face from scratching and dirt. Yaesu FT-101 is a model line of modular amateur radio transceivers, built by the Yaesu Corporation in Japan during the 1970s and 1980s.
The set was built by the Yaesu Corporation in Japan in the late 1970s and early 1980s. Its first Japanese release was in 1976. This transceiver was very small for its time; by current modern standards however it is a large mobile set. It is a low-power (QRP) SSB and CW transceiver of which transmitting power is adjustable up from 10 to about 20 W.
The Yaesu VX-1R is a micro-miniature multiband FM transceiver with extensive receiver frequency coverage intended for use in licensed "Ham" or amateur radio operations. It is purportedly the smallest UHF/VHF hand-held transceiver available, with dimensions of 4.7 × 8.1 × 2.5 cm (1.9 × 3.2 × 1.0 in).
The FT-817 is based on a similar circuit architecture as Yaesu's FT-857 and FT-897, so it is a compromise transceiver and incorporates its features to its low price ($670.- at its 2001 release). [3] The upgraded FT-817(N)D was launched in 2004. The difference between the two models is the addition of 60 meter band coverage in 5 fixed channels ...
The receiver is filtered by a 22 pole crystal filter with switchable extra 8 and 6 pole narrow band CW filters, a 14 pole SSB filter and a separate 14 pole CW filter. The RF circuit is based on a – manually or automatically – microprocessor controlled PIN diode attenuator with 2 bipolar power transistors used as a high level RF amplifier in the receive mode and as a double RF output pre ...