Ads
related to: grade 8.8 bolt tightening torque calculation table pdf printable black and white
Search results
Results From The WOW.Com Content Network
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...
SAE Grade 0 [48] Strength and hardness is not specified SAE grade 1 ASTM A307 [49] Low carbon steel 1 ⁄ 4 – 1 + 1 ⁄ 2: 33 230 60 410 B70–100 ASTM A307 - Grade B [49] Low or medium carbon steel 1 ⁄ 4 –4 60 minimum 100 maximum 410 minimum 690 maximum B69–95 SAE grade 2 Low or medium carbon steel 1 ⁄ 4 – 3 ⁄ 4: 55 380 57 390 74 ...
Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm [8] With exception to part 7, which defines test standards, the parts of this standard define properties for fasteners made of carbon steel and alloy steel .
Elevator bolt - Bolt with a large flat head used in conveyor system setups. Hanger bolt - Bolt that has no head, machine threaded body followed by a wood threaded screw tip. Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for ...
The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).