Ads
related to: best time for 802.11 multicast wifi cable connection
Search results
Results From The WOW.Com Content Network
Timing synchronization function (TSF) is specified in IEEE 802.11 wireless local area network (WLAN) standard to fulfill timing synchronization among users. A TSF keeps the timers for all stations in the same basic service set (BSS) synchronized. All stations shall maintain a local TSF timer.
Task Group mc (TGmc) of the IEEE 802.11 Working Group, sometimes referred to as IEEE 802.11mc, was the third maintenance/revision group for the IEEE 802.11 WLAN standards. [1] [2] Purpose was to incorporate accumulated maintenance changes (editorial and technical corrections) into IEEE Std 802.11-2012, and roll up approved amendments into the standard.
Annex F In IEEE 1588-2002, all PTP messages are sent using multicast messaging, while IEEE 1588-2008 introduced an option for devices to negotiate unicast transmission on a port-by-port basis. [8]: Clause 16.1 Multicast transmissions use IP multicast addressing, for which multicast group addresses are defined for IPv4 and IPv6 (see table). [8]:
A wireless distribution system (WDS) is a system enabling the wireless interconnection of access points in an IEEE 802.11 network. It allows a wireless network to be expanded using multiple access points without the traditional requirement for a wired backbone to link them.
IEEE 802.11s is a wireless local area network (WLAN) standard and an IEEE 802.11 amendment for mesh networking, defining how wireless devices can interconnect to create a wireless LAN mesh network, which may be used for relatively fixed (not mobile) topologies and wireless ad hoc networks. The IEEE 802.11s task group drew upon volunteers from ...
But in long-range Wi-Fi, special technologies are used to get the most out of a Wi-Fi connection. The 802.11-2007 standard adds 10 MHz and 5 MHz OFDM modes to the 802.11a standard, and extend the time of cyclic prefix protection from 0.8 μs to 3.2 μs, quadrupling the multipath distortion protection.
A station must sense the status of the wireless medium before transmitting. If it finds that the medium is continuously idle for DCF Interframe Space (DIFS) duration, it is then permitted to transmit a frame. If the channel is found busy during the DIFS interval, the station should defer its transmission.
The time-division multiple access (TDMA) channel access scheme is based on the time-division multiplexing (TDM) scheme. TDMA provides different time slots to different transmitters in a cyclically repetitive frame structure. For example, node 1 may use time slot 1, node 2 time slot 2, etc. until the last transmitter when it starts over.