Search results
Results From The WOW.Com Content Network
A T1 feed demultiplexed through a Newbridge channel bank to 24 channels with an Amphenol connector. In telecommunications, a channel bank is a device that performs multiplexing or demultiplexing ("demux") of a group of communications channels, such as analog or digital telephone lines, into one channel of higher bandwidth or higher digital bit rate, such as a DS-1 (T1) circuit, so that all the ...
The T-carrier is a hardware specification for carrying multiple time-division multiplexed (TDM) telecommunications channels over a single four-wire transmission circuit. It was developed by AT&T at Bell Laboratories ca. 1957 and first employed by 1962 for long-haul pulse-code modulation (PCM) digital voice transmission with the D1 channel bank.
The T1 line consists of 23 bearer (B) channels and one data (D) channel for control purposes, [1] for a total bandwidth of 24x64-kbit/s or 1.544 Mbit/s. The E1 carrier provides 30 B- and one D-channel for a bandwidth of 2.048 Mbit/s. [2] The first timeslot on the E1 is used for synchronization purposes and is not considered to be a B- or D ...
In the 1970s it replaced the original T1/D1 framing scheme of the 1960s in which the framing bit simply alternated between 0 and 1. Superframe is sometimes called D4 Framing to avoid confusion with single-frequency signaling. It was first supported by the D2 channel bank, but it was first widely deployed with the D4 channel bank.
There are 23 bearer channels carrying voice or data, and one D channel carrying the Common Channel Signaling. In an NFAS configuration, multiple T1 circuits share a single D channel, with an upper limit of 20 T1 circuits in a single NFAS configuration. A full NFAS configuration can then be described as 479B + D.
A CSU/DSU (channel service unit/data service unit) is a digital-interface device used to connect data terminal equipment (DTE), such as a router, to a digital circuit, such as a Digital Signal 1 (DS1) T1 line. The CSU/DSU implements two different functions.
IBM Turboways ATM 155 PCI network interface card. Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.
73/HCGS/123456/000/CC = T1 Circuit controlled by Consolidated Communications 44/AQDU/987654/000/G3 = HDSL Circuit controlled by G3 Telecom. Parts of this circuit ID may also have additional intelligence (or meaning) built in. For instance, the Prefix may or may not be based on the LATA from one end of the circuit or the other.