Search results
Results From The WOW.Com Content Network
The server then chooses an address and sends the client a unicast message, using the helper to send the message back to the client's subnet. The address is reserved for a limited time while the DHCP server waits for a response. If the client responds with another broadcast message, the DHCP server distributes the address. Helper addresses also ...
A packet-switched network transmits data that is divided into units called packets.A packet comprises a header (which describes the packet) and a payload (the data). The Internet is a packet-switched network, and most of the protocols in this list are designed for its protocol stack, the IP protocol suite.
A named pipe can be accessed much like a file. Win32 SDK functions CreateFile, ReadFile, WriteFile and CloseHandle open, read from, write to, and close a pipe, respectively. Unlike Unix, there is no command line interface, except for PowerShell. Named pipes cannot be created as files within a normal filesystem, unlike in Unix.
In packet switching networks, traffic flow, packet flow or network flow is a sequence of packets from a source computer to a destination, which may be another host, a multicast group, or a broadcast domain. RFC 2722 defines traffic flow as "an artificial logical equivalent to a call or connection."
MAC-Forced Forwarding (MACFF) is used to control unwanted broadcast traffic and host-to-host communication. This is achieved by directing network traffic from hosts located on the same subnet but at different locations to an upstream gateway device. This provides security at Layer 2 since no traffic is able to pass directly between the hosts.
The thought being that traffic is denied if it fails the RPF check and is therefore filtered. While uRPF is used as an ingress filtering mechanism, it is affected by reverse-path forwarding. Reverse path filters are typically used to disable asymmetric routing where an IP application has a different incoming and outgoing routing path.
Before claiming an IP address, the client should probe the newly received address (e.g. with ARP), in order to find if there is another host present in the network with the proposed IP address. [8]: sec. 2.2 If there is no reply, this address does not conflict with that of another host, so it is free to be used. If this probe finds another ...
File Transfer Protocol in active mode, for example, uses separate connections for control traffic (commands) and for data traffic (file contents). When requesting a file transfer, the host making the request identifies the corresponding data connection by its network layer and transport layer addresses. If the host making the request lies ...