Ad
related to: 68 charger steering wheel emblem center cap removal jeep gladiator rubicon
Search results
Results From The WOW.Com Content Network
The Jeep Gladiator, Jeep Pickup or J-series is a series of full-size pickup trucks based on the large Jeep SJ platform, which was built and sold under numerous marques from 1962 until 1988. The Jeep Gladiator/Pickup design is noteworthy for remaining in production for more than 26 years on a single automobile platform generation.
The vehicle's name harkens back to the original Jeep Gladiator, made in 1962 until 1988 and known as the J-Series after 1971.Jeep considered reviving the Gladiator name alongside Comanche and most commonly Scrambler, as well as simply using a new name, before deciding on Gladiator, feeling it fits the truck the best.
The steering wheel and instrument cluster swung aside to allow entry, while the seats elevated and lowered (by 8 in (20 cm) [3]) to ease access. [2] The wheel and instrument cluster was from a 1968 Dodge Charger. [3] Air was admitted to the cockpit through vents at the windshield base. [2] The engine bay would accept any Dodge V8, including the ...
The Jeep Quadra-Trac was differentiated from the open "New Process" Gear NP203 used by Dodge, General Motors, and Ford in that it included a center limited slip differential feature, in this case a clutch pack. Applications: 1973-1979 Jeep Wagoneer (SJ) 1973-1979 Jeep Cherokee (SJ) 1973-1979 Jeep Gladiator; 1976-1979 Jeep CJ-7
1965 Dodge Charger II Show Car. During the early 1960s, automakers were exploring new ideas in the personal luxury and specialty car segments. Chrysler, slow to enter the specialty car market, selected their Dodge Division to enter the marketplace with a mid-size B-bodied sporty car to fit between the "pony car" Ford Mustang and "personal luxury" Ford Thunderbird. [1]
The 1 + 1 ⁄ 4-ton, 4×4, Kaiser Jeep M715, sometimes called the "Five quarter (ton)", for its 1 + 1 ⁄ 4 (or 5 ⁄ 4) ton payload rating, is an American light military truck, based on the civilian Jeep Gladiator (SJ). Design and development for the M715 began in 1965, intended to replace the Dodge M37.
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as " Twin Traction Beam " (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.
With competition from the "big three" automakers advancing on Jeep's four-wheel-drive market, Willys management decided that a new and more advanced vehicle was needed. . Conceived in the early 1960s while Willys-Overland Motors was owned by Kaiser Jeep Corporation, the Wagoneer replaced the original Willys Jeep Station Wagon, originally introduced in July 1946 and produced until the 1964 model