Ads
related to: replacing evap vent valve silverado 5.3 v6 chevy engine
Search results
Results From The WOW.Com Content Network
These bore and stroke dimensions were later used by the 267 cu in (4.4 L) V8 Chevrolet engine. Also like the small block V8 engines, the 200 cu in (3.3 L) V6 used 2.45-inch (62.2 mm) main bearings and 2.1-inch (53.3 mm) rod bearing diameters. Being a 90° V6, Chevrolet took steps to eliminate the rough running tendencies of the 200.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
This was Chevrolet's second 4.3L power plant; four other Chevrolet engines displaced 4.3L: the Vortec 4300 (a V6 based on the Chevrolet 350 cu in (5.7 L), with two cylinders removed), the original 265 cu in (4.3 L) V8 in 1954, a bored version of the stovebolt-era 235 inline six displacing 261 cu in (4.3 L), and a derivative of the Generation II ...
1977–2013 Chevrolet 90° V6 engine (derived from the Chevrolet Small-Block" V8; now marketed as GM Vortec V6 or Vortec 4300 or EcoTec3 V6) 1979–2010 Chevrolet 60-Degree V6; 1994–2005 Opel 54-Degree L81 V6 (used in the Saturn Vue, Cadillac Catera and Saturn L series) 1995–present Suzuki H (used in several models built for GM by Suzuki)
PCV valve on Ford Taunus V4 engine (feeding from left side valve cover into the inlet manifold) A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold).