Search results
Results From The WOW.Com Content Network
Pound per hour is a mass flow unit based on the international avoirdupois pound, which is used in both the British imperial and, being a former colony of Britain, the United States customary systems of measurement. It is abbreviated as PPH, or more conventionally as lb/h.
Comparative passenger capacity per hour of various modes of transport. The corridor capacity in the passenger transport field refers to the maximum number of people which can be safely and comfortably transported per unit of time over a certain way with a defined width. The corridor capacity does not measure the number of vehicles which can be ...
For railways with very high passenger loads, the maximum possible route capacity is an important factor. A common unit for route capacity is people per hour (pph), which can for metro style systems can be as high as 80,000. [citation needed] Route capacity can also be expressed as number of vehicles per hour, such as 16 trains per hour (tph). [6]
Pound per hour (symbol pph), mass flow unit (used in aviation to measure fuel flow, for instance) Part per hundred (percentage) People per hour, a measure of the rate of flow of people moving past a fixed point or through a system; Propylphenidate, an analogue of methylphenidate
Fastest possible cycle time is 1.5 seconds, hence only 21,600 seconds would have been needed to produce the 14,400 parts. The remaining 7,200 seconds or 2 hours were lost. The OEE is now the 21,600 seconds divided by 28,800 seconds (same as minimal 1.5 seconds per part divided by 2 actual seconds per part), or 75%.
In science and technology, an arbitrary unit (abbreviated arb. unit, [1] see below) or procedure defined unit [2] (p.d.u.) is a relative unit of measurement to show the ratio of amount of substance, intensity, or other quantities, to a predetermined reference measurement. The reference measurement is typically defined by the local laboratories ...
Conversion of per-unit quantities to volts, ohms, or amperes requires a knowledge of the base that the per-unit quantities were referenced to. The per-unit system is used in power flow, short circuit evaluation, motor starting studies etc. The main idea of a per unit system is to absorb large differences in absolute values into base relationships.
Full Load hour is a measure of the degree of utilisation of a technical system. [1] [2] [3] Full load hours refer to the time for which a plant would have to be operated at nominal power in order to convert the same amount of electrical work as the plant has actually converted within a defined period of time, during which breaks in operation or partial load operation can also occur.