Ads
related to: stereo output to mono input
Search results
Results From The WOW.Com Content Network
A diagram of monaural sound. Monaural sound or monophonic sound (often shortened to mono) is sound intended to be heard as if it were emanating from one position. [1] This contrasts with stereophonic sound or stereo, which uses two separate audio channels to reproduce sound from two microphones on the right and left side, which is reproduced with two separate loudspeakers to give a sense of ...
Mono equipment receiving stereo output will simply use the left (tip) channel as the mono input signal and lose the right (ring) channel of the stereo audio. The positive (tip) component of a balanced signal will be received, though without the full benefits of balanced audio, since the signal's negative (ring) component will be lost.
Analog microphone audio input (†mono or stereo). Light blue / 284C Analog line level audio input. Lime green / 577C Analog line level audio output. Orange / 157C Analog audio output for the center speaker and Subwoofer Brown / 4645C Analog audio output for "right-to-left" speakers. Gold / 131C MIDI/game
stereo: Audio signal received from the analog CD input of the mixer, which is usually connected to the analog audio output of a CD drive. Microphone mono: Audio signal received through one of the (typically two: MIC1 and MIC2, switchable) analog microphone inputs. MIC1 is typically connected to the external microphone jack (colored pink under ...
Line out provides an audio signal output and line in receives a signal input. The line in/out connections on consumer-oriented audio equipment are typically unbalanced, with a 3.5 mm (0.14 inch, but commonly called "eighth inch") 3-conductor TRS minijack connector providing ground, left channel, and right channel, or stereo RCA jacks.
Using RCA connectors, each signal requires its own plug. Even the simple case of attaching a cassette deck may need four of them – two for stereo input and two for stereo output. In any common setup this quickly leads to a disarray of cables and confusion in how to connect them.
This would turn the stereo amplifier into a mono amplifier. Some two channel amplifiers, or stereo amplifiers, have the built in facility to operate in bridge mode by operating a switch and observing the input and output connections detailed on the back panel or in the manual.
Numerous early two-track-stereo reel-to-reel tapes as well as several experimental stereo disc formats of the early 1950s branded themselves as binaural, however they were merely different incarnations of the above-described stereo or two-track mono recording methods (lead vocal or instrument isolated on one channel and orchestra on the other ...