Ad
related to: rear differential clunking noise when driving
Search results
Results From The WOW.Com Content Network
The rear wheels are located transversely by top links and wheel carriers (green) and lower links (cyan). The top link is the driving half-shaft with a universal joint at each end. The lower link pivots adjacent to the differential casing at its inboard end and where it meets the wheel carrier at the wheel hub casting (violet) at its outboard end.
Differential operation while driving in a straight line: Input torque is applied to the ring gear (purple), which rotates the carrier (purple) at the same speed. When the resistance from both wheels is the same, the planet gear (green) doesn't rotate on its axis (although the gear and its pin are orbiting due to being attached to the carrier).
ARB air-locking differential fitted to a Mitsubishi Delica L400 LWB Diff. A locking differential is a mechanical component, commonly used in vehicles, designed to overcome the chief limitation of a standard open differential by essentially "locking" both wheels on an axle together as if on a common shaft. This forces both wheels to turn in ...
The de Dion tube is shown in blue. The differential (yellow) is connected directly to the chassis (orange). Universal joints are shown in green. De Dion rear axle. A de Dion axle is a form of non-independent automobile suspension. It is a considerable improvement over the swing axle, Hotchkiss drive, or live axle. [1]
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
In the 1890s, the term began to be used in a manner closer to the modern sense. In 1891, for example, Battles referred to the shaft between the transmission and driving trucks of his Climax locomotive as the drive shaft, [4] and Stillman referred to the shaft linking the crankshaft to the rear axle of his shaft-driven bicycle as a drive shaft. [5]
In 1932, Ferdinand Porsche designed a Grand Prix racing car for the Auto Union company. The high power of the design caused one of the rear wheels to experience excessive wheel spin at any speed up to 160 km/h (100 mph). In 1935, Porsche commissioned the engineering firm ZF to design a limited-slip differential to improve performance.
To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...