Search results
Results From The WOW.Com Content Network
The length of each period is determined by the rate of change and the required change in gain. For more intuitive operation, a compressor's attack and release controls are labeled as a unit of time (often milliseconds). This is the amount of time it takes for the gain to change a set amount of dB or a set percentage towards the target gain.
Here, the still-mic-level signal enters into a microphone preamplifier, which boosts the signal voltage to line level. For this example, the microphone preamplifier is built into a mixing board. It is typical for a mixing board to include a line trim after the preamplifier. This allows the amplitude of the now line-level signal to be adjusted.
This means that (1) moving the microphone closer to the sound source increases the signal level produced by the microphone, and (2) moving the microphone further away from undesirable noise sources will diminish the amount of noise in the microphone signal. Microphone placement is therefore an important aspect of gain staging [citation needed].
The crowd at Fiserv Forum, the same venue that hosted July’s GOP convention, chanted at times “fix the mic,” while Trump pulled the microphone out of its holder and held it by hand.
To maximize gain before feedback, the amount of sound energy that is fed back to the microphones must be reduced as much as is practical.As sound pressure falls off with 1/r with respect to the distance r in free space, or up to a distance known as reverberation distance in closed spaces (and the energy density with 1/r²), it is important to keep the microphones at a large enough distance ...
An Alesis Micro Gate noise gate. A noise gate or simply gate is an electronic device or software that is used to control the volume of an audio signal.Comparable to a limiter, which attenuates signals above a threshold, such as loud attacks from the start of musical notes, noise gates attenuate signals that register below the threshold. [1]
In live sound mixing, GBF is dependent on a wide variety of conditions: the pickup pattern (polar pattern) of the microphone, the frequency response of the microphone and of the rest of the sound system, the number of active microphones and loudspeakers, the acoustic conditions of the environment including reverberation and echo, and the relative positions of the microphones, the loudspeakers ...
The equipment for the techniques also varies from the bulky to the small and convenient. A-B techniques generally use two separate microphone units, often mounted on a bar to define the separation. X-Y microphone capsules can be mounted in one unit, or even on the top of a handheld digital recorder.