Search results
Results From The WOW.Com Content Network
Vinyl microgroove phonograph records typically yield 55-65 dB, though the first play of the higher-fidelity outer rings can achieve a dynamic range of 70 dB. [25] German magnetic tape in 1941 was reported to have had a dynamic range of 60 dB, [26] though modern-day restoration experts of such tapes note 45-50 dB as the observed dynamic range. [27]
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
The Sound Reduction Index is expressed in decibels (dB). It is the weighted sound reduction index for a partition or single component only. This is a laboratory-only measurement, which uses knowledge of the relative sizes of the rooms in the test suite, and the reverberation time in the receiving room, and the known level of noise which can pass between the rooms in the suite by other routes ...
4-inch (100 mm) hollow CMU (concrete masonry unit) [34] 45 Double layer of 1 ⁄ 2-inch (13 mm) drywall on each side, wood studs, batt insulation in wall 46 Single layer of 1 ⁄ 2-inch (13 mm) drywall, glued to 6-inch (150 mm) lightweight concrete block wall, painted both sides 46 6-inch (150 mm) hollow CMU (concrete masonry unit) [34] 48
An LP made out of perfect vinyl would have a theoretical dynamic range of 70 dB, [6] though measurements indicate actual performance in the 60 to 70 dB range. [7] [failed verification] Compare this to digital recording. Typically, a 16-bit digital recording has a dynamic range of between 90 and 95 dB. [8]: 132
dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...
While describing sound in terms of sound pressure, a logarithmic conversion is usually applied and the sound pressure level is stated instead, in decibels (dB), with 0 dB SPL equal to 20 micropascals. A microphone is distinguishable by the voltage value produced when a known, constant root mean square sound pressure is applied. This is known as ...
For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu). Examples. 100 dBμ or 100 mV/m: blanketing interference may occur on some receivers