Search results
Results From The WOW.Com Content Network
Vapor lock is a problem caused by liquid fuel changing state to vapor while still in the fuel delivery system of gasoline-fueled internal combustion engines.This disrupts the operation of the fuel pump, causing loss of feed pressure to the carburetor or fuel injection system, resulting in transient loss of power or complete stalling.
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]
Low-speed pre-ignition (LSPI), also known as stochastic pre-ignition (SPI), [1] is a pre-ignition event that occurs in gasoline vehicle engines when there is a premature ignition of the main fuel charge. [2] LSPI is most common in certain turbocharged direct-injection vehicles operating in low-speed and high-load driving conditions. [3]
The only problem experienced with this M111 excellent reliability motor is the originally installed Victor Reinz headgasket, which eventually tore apart by age, and made the top lose coolant on the side. Other than that, only some year models, had bad insulation on the engine wiring, that needed all the wiring to be replaced.
British Airways Flight 38 crash-landed at London Heathrow in 2008 after its fuel lines became clogged with ice crystals.. In an internal combustion engine, fuel starvation is the failure of the fuel system to supply sufficient fuel to allow the engine to run properly, for example due to blockage, vapor lock, contamination by water, malfunction of the fuel pump or incorrect operation, leading ...
Common rail fuel system on a Volvo truck engine. In 1916 Vickers pioneered the use of mechanical common rail systems in G-class submarine engines. For every 90° of rotation, four plunger pumps allowed a constant injection pressure of 3,000 pounds per square inch (210 bar; 21 MPa), with fuel delivery to individual cylinders being shut off by valves in the injector lines. [1]
Electronically controlled mechanical fuel injection. The engine control unit (ECU) may be either analog or digital, and the system may or may not have closed-loop lambda control. The system is based on the K-Jetronic mechanical system, with the addition of an electro-hydraulic actuator, essentially a fuel injector inline with the fuel return.
MAP sensors measure absolute pressure. Boost sensors or gauges measure the amount of pressure above a set absolute pressure. That set absolute pressure is usually 100 kPa. This is commonly referred to as gauge pressure. Boost pressure is relative to absolute pressure - as one increases or decreases, so does the other.