Ads
related to: washing machine capacitor not working on whirlpool oven error f3 manual
Search results
Results From The WOW.Com Content Network
The wig-wag is the common name for the unusual solenoid mechanism used in belt-drive washing machines made by Whirlpool, Kenmore (manufactured by Whirlpool) and others, from approximately 1950 to 1987 in the United States. [1] It was used in belt-drive Brastemp and Consul models built in Brazil from 1959 to 1990.
A selection of major appliances. A major appliance, also known as a large domestic appliance or large electric appliance or simply a large appliance, large domestic, or large electric, is a non-portable or semi-portable machine used for routine housekeeping tasks such as cooking, washing laundry, or food preservation.
Unlike a resistor, an ideal capacitor does not dissipate energy, although real-life capacitors do dissipate a small amount (see Non-ideal behavior). The earliest forms of capacitors were created in the 1740s, when European experimenters discovered that electric charge could be stored in water-filled glass jars that came to be known as Leyden jars .
The predominant application of all electrolytic capacitors is in power supplies.They are used in input and output smoothing capacitors, as decoupling capacitors to circulate the harmonic current in a short loop, as bypass capacitors to shunt AC noise to the ground by bypassing the power supply lines, as backup capacitors to mitigate the drop in line voltage during sudden power demand or as ...
At low frequencies parasitic capacitance can usually be ignored, but in high frequency circuits it can be a major problem. In amplifier circuits with extended frequency response, parasitic capacitance between the output and the input can act as a feedback path, causing the circuit to oscillate at high frequency.
The energy (measured in joules) stored in a capacitor is equal to the work required to push the charges into the capacitor, i.e. to charge it. Consider a capacitor of capacitance C, holding a charge +q on one plate and −q on the other.
if heat dissipation is poor, so that normally produced waste heat does not drain away properly. Overheating may be caused from any accidental fault of the circuit (such as short-circuit or spark-gap), or may be caused from a wrong design or manufacture (such as the lack of a proper heat dissipation system).