Ad
related to: installing fascia board on rafters on a house roof ideas
Search results
Results From The WOW.Com Content Network
Eaves of a house in Northern Australia. The white underside would be referred to as a soffit. In this example the soffit is fixed to the slope of the rafters. The dark grey fascia boards form the outer edge and have a groove to receive the soffit lining sheets which cover the rafter tails. Boxed in soffit on a house in Northern Florida, United ...
Fascia (/ ˈ f eɪ ʃ ə /) is an architectural term for a vertical frieze or band under a roof edge, or which forms the outer surface of a cornice, visible to an observer. [ 1 ] Typically consisting of a wooden board, unplasticized PVC (uPVC), or non-corrosive sheet metal, many of the non-domestic fascias made of stone form an ornately carved ...
A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.
The trim and rafters at this edge are called rakes, rake board, rake fascia, verge-boards, barge-boards or verge-or barge-rafters. [3] It is a sloped timber on the outside facing edge of a roof running between the ridge and the eave. [4] On a typical house, any gable will have two rakes, one on each sloped side.
Eaves must be designed for local wind speeds as the overhang can significantly increase the wind loading on the roof. [ 7 ] The line on the ground under the outer edge of the eaves is the eavesdrip , or dripline, and in typical building planning regulations defines the extent of the building and cannot oversail the property boundary.
Bargeboard, 1908 illustration. A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof.
A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture, Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."
Section view through a house roof drawing showing names for parts of the structure. [clarification needed] (UK and Australia). Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1]