Search results
Results From The WOW.Com Content Network
bolt circle: BCD or B.C.D. bolt circle diameter: BHC bolt hole circle Same definition as the bolt circle diameter BHCS: button head cap screw: Like an SHCS but with a button head. BHN: Brinell hardness number: BoM or BOM: bill of materials: Also called a list of materials (LM or L/M). Overlaps a lot in concept with a parts list (PL or P/L ...
An elevator bolt is a similar to a carriage bolt, except the head (or foot, depending on the application) is thin and flat. There are many variations. [11] Elevator bolts are designed to be used for leveling appliances or furniture. eye bolt: An eye bolt is a bolt with a looped head.
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.
The hex head is used to drive the bolt into the countersunk hole, then either a wrench or hammer is used to break the shank and hex head from the flat head, or it is driven until the driving head shears off. Either method leaves only a smooth bolt head exposed. This type of bolt is commonly used with prison door locks, automobile ignition ...
The countersunk head has a Pozidriv recess. A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Bolt stump In lever tumbler locks, a bolt stump is a rectangular part located above the talon, and passes through the slot in the levers as the bolt moves. [4] Bottom pin See key pin. Break A break in the pins is a separation in one or more sections of the pin used to encode the lock for a specific key or set of keys in a master keying system ...
1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard. The Mitsubishi transmission was made to fit Mustang IIs and was shoehorned into the early Rangers.